cam actuates the rear brake wheels
Greetings to all from these tropical latitudes, something warm, unstable and radical in terms of climate concerns in this opportunity I will explain in a very simplified as to mount the rear brake lever, a task which by its nature is very simple to make . Tuesday, April 13, 2010
Are Facewash Supposed To Sting
Tools they will need:
1 - The best in the world, our hands.
2-A 10mm combination wrench, see photo # 1.
Photo # 1-10mm combination wrench.
Steps for mounting the cam.
1-Previously we have to have the slide-mounted bands and can be done without the need for it, is installed in the rear wheel, grabbed the cam which drives the rear brake and proceed to bring it closer to the grooved tip.
2-inserted the cam with caution as the exterior of the tip where to go, is striated, like the inside of the cam, therefore, has only one way to fit, must feel that be inserted easily, if you feel forced stop coming!, as some are doing wrong or being forced.
The cam has a spit marking, see yellow arrow and the top of the fluted point is an equal, see red arrow, why are these points?, Therefore, to align them, so there is no margin of error on how it should be mounted cam with respect to the grooved tip.
assure
3-cam, placing its pin grooved 10 mm as shown in the green arrow.
4-screwing it gently, first hand, to the left.
5-tighten using 10mm bolt that gives security to the whole, rather, we fit only, is not necessary to be Conan the Barbarian in this part.
"The end result?
should look like this, if not, something definitely did wrong.
I say goodbye again, but you all again soon, I hope you find it good this simple explanation.
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment